Categories
DIY Guides

How To Convert Sony A5000 to Infrared 720nm or Full Spectrum

The Sony A5000 is a great camera that also is suitable for infrared photography.

You will need:

• Small Philips and flat screwdrivers
• 3M double sided tape
• Hot air blower
• Nitrile gloves
• ESD bracelet
• Cut to the dimensions infrared filter or clear glass

Some technicians doing full spectrum conversion do not stick a piece of glass to the sensor leaving it exposed to dust. I do not do this as to remove any dust then is an arduous and time-consuming task.

The disassembly is more complicated compared to other cameras out there.

We can start by unscrewing all the screws we will find on it.

Now, we must unscrew three flash screws.

And we will disconnect a ribbon cable.

Be extra careful with this ribbon cable as it can break easily. To slide it out I usually use a wooden cocktail stick or a small flat screwdriver with extra carefulness.

The back plastic can be removed by pulling a long piece next to the flash.

Now we will remove the control wheel.

It should slide to the top. There is a clip you need to move with a small screwdriver.

Carefully disconnect the ribbon cable.

Now unscrew LCD screw and disconnect its ribbon cable.

Now, we will remove plastic piece – a flash bracket.

Now unscrew all the screws that hold this metal piece.

Take out the metal piece. It should go out smoothly; just pull it gradually from each side.

Unscrew one screw and take out the metal piece with a cooling pad.
Take out the protective insulation.

Disconnect all the ribbon cables and take out the logic board. There will be one hidden ribbon cable on the left. Carefully disconnect it using a small flat screwdriver. There will be two microphones on the top. Carefully take them out using small tweezers.

There will be a black plastic piece that has no screws fitted, but you must start from the place I have marked.

Disconnect the two ribbon cables and unscrew screws from the metal gasket. Take it out.

Unscrew three screws holding the sensor and take the sensor out.

Do not lose those shims and remember where which one is located.

Now, you will need a hot air blower and a save knife.

Heat up the sensor and separate the front glass from it.

Remove the old double-sided tape if there is some left.

Cut two longer and two shorter pieces of 3M double sided tape (approx. 2mm wide).

Stick it to the sensor’s plastic.
Make sure you are in a dark room. Using LED light remove any dust from the sensor and from the filter glass. I use a piece of microfiber cloth.
Stick the filter to the sensor.
Assemble the camera.

If you have a filter glass that is 2mm thick, you will need to use 0.4mm thick washers (2mm x 4.5mm x 0.4mm) to move the sensor slightly to the back.

Is the kit lens any good for infrared? Unfortunately, the Sony 16-50 kit lens has a spot-on high aperture number.

Leave a Reply

Your email address will not be published. Required fields are marked *